![]() ![]() The blade might be damaged by moving the carriage outside the media under this condition. Setting will affect both ends, resulting the total width change will be double the set value.ĬAUTION: Do not se the "initial blade control position" of the special function to "outside" when the setting value is set to more than 8 mm. ![]() ![]() The width will enlarge if the value is set to positive, and the width will decrease if the value is set to negative. It is possible to set so the cutter cut the area up to 10 mm (positive value) outside the push roller, or 10 mm (negative value) inside from the default position, or not to cut the end of the media. CP FAQ VIDEO REGISTRATION MARK FOR EXPANDED AREA CONTOUR CUTĭefault setting is set cut internal area at the edge of the push rollers.CP FAQ VIDEO PRINT AND CUT SETTING CUTTING WIDTH / SETTING PAGE LENGTH.CP FAQ VIDEO PRINT AND CUT ISSUES NOT READING MARKS.CP FAQ VIDEO PRINT AND CUT SETTING SPEED OF THE REGISTRATION MARK SCAN.CP FAQ VIDEO PRINT AND CUT ADJUSTING THE SENSOR LEVEL.CP FAQ VIDEO CUTTING MASTER 4 AND GRAPHTEC PRO STUDIO INSTALLATION.CP FAQ VIDEO PRINT AND CUT OFFSET ISSUES.CP FAQ VIDEO INSTALLATION CUTTING MASTER 4.CP FAQ VIDEO INSTALLATION GRAPHTEC PRO STUDIO.CP FAQ VIDEO GRAPHTEC PRO STUDIO TRUE SHAPE NESTING MODULE. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |